Inground & Above ground pool heaters (2024)

Solar swimming pool heaters rely entirely on the sun's energy to heat pool water. As water circulates through the solar panels, heat from the sun's rays is transferred into the water. While some solar swimming pool heaters are designed to be set up on rooftops or mounted on wooden racks, other models can be installed on the ground.

Pros and Cons of Solar Pool Heaters

    • Low Initial Cost
    • Zero Cost to Operate
    • Ecofriendly, Zero Emissions
    • Entirely Weather Dependent
    • Lower Heat Gain

Solar pool heaters for pools are less expensive to buy than gas-fired heaters or pool heat pumps, but if you want to add 15-20 degrees F to the water, you need to use enough solar panels to equal at least 50% of the pool surface area. For most inground pools, a good solar system will cost $1500-$2000, still one of the cheapest methods of heating a pool. For most above ground pools, a good solar system will cost $250-$750, still one of the cheapest methods of heating a pool.

With no cost to operate the solar panels, other than the cost of running the filter pump, which you are may be doing anyway, solar pool heating is the least costly way to heat an inground pool.

In terms of environmental friendliness, solar pool heating is the clear leader. No fossil fuels, no emissions, no fuels or refrigerants needed, only the sun; a renewable resource. Solar panels, made entirely of thermoplastics, are also more easily recycled than other pool heater types.

The largest drawback to solar pool heaters is that they are entirely dependent on sunny weather. They can still heat the pool on warm and partly cloudy days, but with cool and rainy weather solar heaters lose heat, and they don’t work at all during the night.

Another disadvantage attributed to solar pool heaters is lower overall heat gain. However, solar systems are modular, and the more panels you have, the greater heat you can add to the water. If you have a sunny southern facing location to place enough panels to equal 50-80% of your pool surface water, and you get at 6-8 hours of daily unobstructed sun - you can match the heat output of a gas heater or heat pump, adding 20-30 degrees F to the pool. A small solar system however, or one with only 4-6 hours of daily unobstructed sun may only gain 5-10 degrees, which is easily lost with a few cloudy days.

What does the Ideal Solar Pool Heater System look like?

A southern facing single story roof that’s at least 20’ long, with unobstructed sun, for at least 6 hours daily would be best. Even better if it is close to the pool pump and filter, so that long plumbing runs aren’t required. Another good location would be a free standing, triangular shaped rack, built of slotted angle bracing or lumber framing with a plywood deck. These can be placed up against a fence, on the sunny side. Or a pergola or pool cabana can be used, if the roof has a 10' width.

How many solar panels are needed?

The more panels you have, the more heat you can harvest. Swimming pools in ideal solar conditions should use at least 50% of the pool surface area, For example, an 18x36’ pool has a surface area of 648 square feet. 50% of that would be 324 feet of solar panel surface area, or about 4 of the 4’x20’ panels, which are 80 sq ft each. In less than ideal conditions, such as an east/west orientation, or partial sun obstruction from trees or houses, a higher multiplier of 70-80% can be used, to compensate for panels that receive less direct continuous sun. Remember that the sun is always moving across the sky as our seasons change. A large tree that doesn’t block the sun during May could be a real shade tree in September. Also you need enough solar panel surface area to make a reasonable difference. An undersized solar system will only produce 5-10 degrees of heat.

Can solar panels be installed on separate roofs?

Yes, you can install separate sets of panels, in series, on different facing roof sections for instance. The water will run through the first panel set, exit and then enter the second set of panels.

Do I need a booster pump?

No, most solar systems operate just fine on the volume of water pushed from the existing filter pump. Even installing panels on a second story roof is no problem for most inground pool pumps. There are instances where a larger filter pump or booster pumps are recommended, but these are not the norm.

Installing a Solar Pool Heater System

Not too difficult to do, most in ground pool solar heaters can be installed in one day. Above ground solar heaters can be installed in less than an hour. Location is most important, so after figuring out if you will install on a roof, fence or deck, the panels can be installed. A southern orientation is best in the US, and installing at a 45 degree angle will absorb more heat. The solar panels can be roof mounted in a few hours, secured to protect them from winds. Then you connect plumbing from the return line, after the filter, to the panels on the roof, securing vertical pipes to the wall. The final step is usually wall mounting the solar controller and installing the temperature sensors.

Care and Maintenance of a Solar Pool Heating System

Solar heating systems require very little maintenance. It is important to keep your pool water balanced and your filter in good operating condition. Since the water that goes into the solar collector comes straight from the filter, if there is anything that bypasses the filter, it can potentially clog the solar collector.

Improper pH and calcium hardness can cause mineral build up in the solar collectors. Low pH or high levels of chlorine can cause the plastic to become brittle. If you have very high calcium hardness levels in your pool, use a scale inhibitor on a regular basis to prevent mineral build up in the solar collector.

Although rare, splits or damage to the tubes in a roof mounted solar pool heater can be repaired with an inserted plastic sleeve. This works similar to a stint placed in a blocked artery. One of the greatest things about solar pool heaters is their reliability, and simple design.

How long do solar pool heaters last?

Ironically, the summer sun will eventually attack a solar pool heater, causing it to become brittle and breakdown. Most polypropylene solar heater panels will last at least 10 years in the hottest parts of the country, and longer in the more temperate regions. More durable solar panels made of rubber can last 20 years or more before the material begins to weaken.

Winterizing a Solar Heating System

Most solar heating systems have drain plugs to allow the water to drain out of the panels. They are often installed at a slight tilting angle to facilitate drain down. For proper winterization, it’s a good idea to blow air through the collector to remove any trapped water in the panels or on top of a vertically mounted check valve. Winterizing is also a good opportunity to inspect the collector panel for damage and inspect the mountings; to be sure the solar panels are secure and ready for the winter.

Solar panels for pools are typically manually operated by turning a valve to direct water into the solar panels. When sunny conditions wane, you must remember to turn the solar panels off again, or the water will radiantly cool as it passes through the cold panels. To avoid this, and to enjoy the convenience of setting a desired temperature, solar pool heaters can be controlled with the installation of a Solar Controller. These automatically turn a valve to send water to the solar panels when sensors signal that solar heating conditions are good, and bypass the solar panels when conditions are poor, or when the pre-set temperature is reached.

Sizing a solar heater for pools is done by measuring your pool’s total surface area, by multiplying the length x width. Buy enough solar panels to equal 50-80% of your pool surface area. For example, a 20’x40’ pool would have 800 sq. ft. of surface area, and would require 400-650 sq. ft. of solar panel surface area, for best results. The more solar panels you add; the more heat you get. It’s a good idea to oversize solar pool heaters, for windy areas, uncovered pools, or to compensate for bad weather. For above ground pools, consider modular units like the SunCoil Solar Dome.

Installation of a pool solar heater involves placing the solar panels in an area of unobstructed sun, cutting the return line after the filter, and redirecting the water through the solar panels. Valves are used to direct the water to the panels, and also to bypass the panels. For best results, a solar controller can be mounted, with sensor and valve actuator connected, to maintain a consistent temperature more easily. Solar pool heater installation is much less complicated than other methods, and the only one that is truly DIY friendly and fully achievable by most pool owners.

Solar pool heaters require no maintenance and will typically last for 10 to 15 years, before ironically, the plastic degrades from the sun’s solar rays.

Solar heaters are powerfully fast heaters in direct summer sun, but lose effectiveness in cooler, off-season months, when the sun moves lower through the sky. As such, they are not appropriate for year round pool heating, with exception to far southern regions of North America. For most northern regions, properly sized solar heaters can maintain warm water from May-October.

Inground & Above ground pool heaters (2024)

FAQs

Is there a difference between inground and above ground pool heaters? ›

A heater that is for an above ground pool will have a lower BTU than in-ground pool heaters. Generally, inground pool heaters have more water to heat and need more BTUs. Liquid heat blankets, solar rings, and solar blankets are not rated by BTUs.

Can you put a pool heater on an above ground pool? ›

A pool water heater is a permanently installed and effective heater that can work with some types of above ground pools. It is the most expensive option but can easily raise water temperature by 30 degrees or more.

Are above ground pool heaters worth it? ›

Without a pool heater, the temperature of the water may fluctuate throughout the summer depending on the temperature of the air during the day and at night. Installing a pool heater helps ensure a comfortable swimming experience by stabilizing, regulating, and increasing pool water temperature.

What is the cheapest way to heat an inground pool? ›

That's why we are sharing these ideas for how to cheaply heat a pool, including the absolute cheapest way to heat a swimming pool.
  1. Use solar heating as the primary source. ...
  2. Use your heat pump during warmest time of the day. ...
  3. Use pool blankets to control evaporation. ...
  4. Shield your pool from the wind.

What size pool heater do I need for a 15000 gallon pool? ›

For pools under 10,000 gallons, small gas heaters like the Hayward 100K$) BTU output are suitable. Pools up to 15,000 gallons should look at the Pentair 125K BTU or higher, and 20,000 gallon above ground pools should look at the Raypak 150K BTU.

How many BTU do I need to heat a 20,000 gallon pool? ›

4,980,000 / 24 = 207,500 Btu per hour

This means that it would take 207,500 Btu per hour in order to raise this 20,000 gallon pool from 50 degrees up to 80 degrees in a 24 hour period of time.

What is the best option for an above-ground pool heater? ›

A heat pump is like a reverse air conditioner: the heat pump grabs heat from the outside air and transfers it to the colder pool water. It is one of the more efficient ways to heat your pool and an easier install because it only needs a power line to operate.

How many degrees will a pool cover heat a pool? ›

How Quickly Will a Solar Cover Heat my Swimming Pool? According to the experts, a fully covered pool will heat between 10-15 degrees in about 6 hours. There is mixed information out there. Some experts say that you will get 7-10 degrees with three consecutive days of sun.

What is the fastest way to heat an above-ground pool? ›

When rapid heating is required, gas pool heaters are the go-to option. They utilize natural gas or propane to generate heat, allowing you to quickly warm up your above-ground pool, regardless of external temperatures.

Is it OK to run pool heater all night? ›

You Should Never Leave a Conventional Pool Heater on Overnight. Although electricity and gas costs can vary wildly depending on where you live and how much energy usage is typical for your area, heating pools with conventional heaters can be costly if time is not taken into consideration.

Is it cheaper to run pool heater continuously? ›

Also, turn the temperature down or turn off the heater whenever the pool won't be used for several days. This will save energy and money. It's a myth that it takes more energy to heat a pool back up to a desired temperature than you save by lowering the temperature or turning off the heater.

Is it better to oversize a pool heater? ›

The higher the BTU, the more quickly you will be able to heat your water. This measurement applies to both natural gas and electric heat pumps. Pro Tip: Always go with the largest size (BTU) of heater your pool can accommodate. This leads to quicker water heating and lower operating costs.

How do I know which pool heater to buy? ›

How to Measure the Right Size Pool Heater
  • Calculate Your Pool's Surface Area. ...
  • Determine Your Pool's Average Depth. ...
  • Calculate Your Pool's Approximate Volume in Gallons. ...
  • Calculate the BTUs You Need in a Pool Heater. ...
  • Minimum BTUs Needed for 70-degree Fahrenheit Weather. ...
  • Minimum BTUs Needed for 60-degree Fahrenheit Weather.
Feb 13, 2024

Can I use an inground pool robot in an above ground pool? ›

Most robotic pool cleaners can work well in both in-ground and above-ground pools, but some models are specifically designed for use in only one of those types.

Do inground pools hold heat better? ›

The main difference between an above-ground pool and an in-ground pool is that the above-ground pool loses heat at a much greater rate. That's because heat escapes through the sides, as well as the top.

What is the most efficient inground pool heater? ›

An electric heat pump is most efficient in warmer climates, as plenty of warm air is available for the pump to pull in – not so much in cooler climates or areas with shorter warm seasons. In those situations, a gas heater may be more efficient.

Top Articles
Latest Posts
Article information

Author: Geoffrey Lueilwitz

Last Updated:

Views: 6556

Rating: 5 / 5 (80 voted)

Reviews: 95% of readers found this page helpful

Author information

Name: Geoffrey Lueilwitz

Birthday: 1997-03-23

Address: 74183 Thomas Course, Port Micheal, OK 55446-1529

Phone: +13408645881558

Job: Global Representative

Hobby: Sailing, Vehicle restoration, Rowing, Ghost hunting, Scrapbooking, Rugby, Board sports

Introduction: My name is Geoffrey Lueilwitz, I am a zealous, encouraging, sparkling, enchanting, graceful, faithful, nice person who loves writing and wants to share my knowledge and understanding with you.